Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
how can I find
allenh
Member Posts: 117
a heating contractor that will not shotgun parts and troubleshoot to the actual bad part?
Its a well know American made boiler - Burnham Revolution.
Have intermittent problem where boiler is called in and does not turn on. Had one company go in who were licensed, without a volt meter. They turned power off and on and it fired. I am sure it will happen again. Contractor wanted to just swap out parts by guessing :-(
I would go out there but after falling off a ladder a few days ago I will be home for weeks / months.
Any ideas ? Location is Waltham Mass.
Its a well know American made boiler - Burnham Revolution.
Have intermittent problem where boiler is called in and does not turn on. Had one company go in who were licensed, without a volt meter. They turned power off and on and it fired. I am sure it will happen again. Contractor wanted to just swap out parts by guessing :-(
I would go out there but after falling off a ladder a few days ago I will be home for weeks / months.
Any ideas ? Location is Waltham Mass.
0
Comments
-
tech support
most manufacturers have a tech support line, why not give them a call? unfortunately the safety devices of today, are more difficult to troubleshoot than yesterday's pilot light and thermocouple.--nbc0
This discussion has been closed.
Categories
- All Categories
- 86K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 52 Biomass
- 421 Carbon Monoxide Awareness
- 81 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.3K Gas Heating
- 96 Geothermal
- 154 Indoor-Air Quality
- 3.3K Oil Heating
- 60 Pipe Deterioration
- 893 Plumbing
- 5.9K Radiant Heating
- 379 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 52 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements