Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
small packaged pump and heat exchanger
What manufacture has the small modular pre-piped heat exchanger and pump mounted in a small cabinet?
0
Comments
-
Navien
heat box0 -
0
-
Taco
X-Pump Block
http://www.taco-hvac.com/en/products/X-Pump+Block%99+(XPB)/products.html?current_category=345
8.33 lbs./gal. x 60 min./hr. x 20°ΔT = 10,000 BTU's/hour
Two btu per sq ft for degree difference for a slab0 -
Both are nice
I will have to build the three I need in the field. These prefabs are rated at 125psi maximum working pressure. The system they are going on is rated at 160psi heating hot water. I called Slant-Fin about the heat exchanger in their unit and it's rating and they gave me the answer of 125psi based on the pumped side. Taco also says 125 psi. I am not concerned about the pumped side pressure. The Combi Cat was looking real nice.0
This discussion has been closed.
Categories
- All Categories
- 86.3K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 100 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 64 Pipe Deterioration
- 917 Plumbing
- 6.1K Radiant Heating
- 381 Solar
- 14.9K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements