Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
EK1 system 2000 gas question
marshmallowman
Member Posts: 1
I have to perform an annual clean and tune on a system 2000 gas fired boiler. I'm not savvy with that system. It's a residential unit. I understand it's a front clean out. Can anyone give me some guidance on the procedure?
0
Comments
-
Does manufacturer have instructions on its web site?
For my W-M Ultra 3 boiler, the complete installation manual is on-line on W-M's web site: about 100 pages. It has complete servicing instructions including CO and CO2 readings, pH of water, cleaning heat exchanger, torque readings for bolt tightening, etc., in that manual.
If you are in luck, the manufacturer of the EK1 system 2000 has a similar manual on-line.
Alternatively, does your wholesaler have a manual for it?0 -
EK info
marshmallowman, check your e-mail. We don't have manuals online yet. Send an e-mail, I'll e-mail one.
Anyone else who needs info, manuals etc, contact us directly at 800-323-2066, we don't sell through wholesalers.0
This discussion has been closed.
Categories
- All Categories
- 86.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 52 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 99 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 913 Plumbing
- 6K Radiant Heating
- 381 Solar
- 14.8K Strictly Steam
- 3.3K Thermostats and Controls
- 53 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements