Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Copper Fin Tube Radiation

CDM2
Member Posts: 18
I ran into a type of base board radiator I have not seen before, hope someone can help me identify. It is copper fin tube, 1/2" copper tubes, inlet-outlet on the same end with U-bend at the opposite end. The aluminum fin pack is 5.5" high, 2.0" deep. The fin tube inside the enclosure has a fin spacing of 6 FPI. The exposed fin tube in the basement has fin spacing of 4 FPI. I am trying to identify btu/ linear feet at 150 up to 180 degrees F average water temp.
Any help would be greatly appreciated.
Regards,
Dean
Any help would be greatly appreciated.
Regards,
Dean
CDM2
0
This discussion has been closed.
Categories
- 117.3K All Categories
- 82.7K THE MAIN WALL
- 2.7K A-C, Heat Pumps & Refrigeration
- 42 Biomass
- 400 Carbon Monoxide Awareness
- 7 Chimneys & Flues
- 1.6K Domestic Hot Water
- 4.3K Gas Heating
- 106 Geothermal
- 148 Indoor-Air Quality
- 2.7K Oil Heating
- 45 Pipe Deterioration
- 673 Plumbing
- 4.8K Radiant Heating
- 353 Solar
- 13.2K Strictly Steam
- 2.9K Thermostats and Controls
- 47 Water Quality
- 31 Industry Classes
- 64 Job Opportunities
- 11 Recall Announcements