Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
\"Fan Motor for Homart Wall furnace direct vent\"
Sew- kul
Member Posts: 9
I am looking for a 115v. 1050 rpm. 3.5" diameter 1/20 hp. fan motor. Shaft is 1/4"x 2." Rotation is clockwise, looking at face. Any help would be much appreciated. I've tried the usual sources...Such as Dreisilker motor rebuilders, Grainger, A.O.Smith motors,General electric, Sears, and Magnatec.
0
Comments
-
Try Grainger
0 -
That's already on his list....
He may need to replace the wall furnace. He may, if he has the money available, get the motor rebuilt at a motor shop. He'll get out cheaper if he replaced the wall furnace.0 -
motor needed
try Johnstone supply if u have 1 in your area.0
This discussion has been closed.
Categories
- All Categories
- 86K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 52 Biomass
- 421 Carbon Monoxide Awareness
- 80 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.3K Gas Heating
- 96 Geothermal
- 154 Indoor-Air Quality
- 3.3K Oil Heating
- 60 Pipe Deterioration
- 892 Plumbing
- 5.9K Radiant Heating
- 378 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 52 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements