Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Cg3 standing pilot
Damien D'Antonio
Member Posts: 1
I have a cg3 standing pilot. Brand new the pilot keeps going ount. I found when running the cast iron block is wet at the top. The vent into the chimney is dry but the the block is wet. The block then drips down hits the burner and knocks the pilot out. What are my options.
0
Comments
-
Was it pressure tested.
Is it condensation or do you have a leak. Does the boiler ever get over 140F and if so for how long.
Type of radiation are you attached to.
Are you sure you are venting properly.
Was a proper combustion test done including gas pressures on start up.
Mitch S.
To Learn More About This Professional, Click Here to Visit Their Ad in "Find A Professional"0
This discussion has been closed.
Categories
- All Categories
- 86.7K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 56 Biomass
- 423 Carbon Monoxide Awareness
- 102 Chimneys & Flues
- 2K Domestic Hot Water
- 5.6K Gas Heating
- 103 Geothermal
- 158 Indoor-Air Quality
- 3.5K Oil Heating
- 68 Pipe Deterioration
- 935 Plumbing
- 6.2K Radiant Heating
- 385 Solar
- 15.3K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 43 Industry Classes
- 47 Job Opportunities
- 18 Recall Announcements