Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
looking for steel radiator element
Options
bob_101
Member Posts: 1
I need to replace a steel radiator element 60 inches long x 6 inches deep x 8 inches high for a hot water system. Length and depth is not a problem - Governale stocks them in 2 inch height - but the 8 inch height is proving impossible. One possibility - cast iron element but would rather stick with steel. Any suggestions on a supplier?
0
Comments
-
Slant Fin?
May make "bare" fin-tube that's close. Check their web-site.
Could you not take the 2" high assemblies and simply manifold/stack them times-four, to get the output suggested?
To Learn More About This Professional, Click Here to Visit Their Ad in "Find A Professional"0
This discussion has been closed.
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 49 Biomass
- 418 Carbon Monoxide Awareness
- 71 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 160 Indoor-Air Quality
- 3.2K Oil Heating
- 59 Pipe Deterioration
- 848 Plumbing
- 5.8K Radiant Heating
- 371 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 50 Water Quality
- 38 Industry Classes
- 47 Job Opportunities
- 15 Recall Announcements