Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Wedi Board...
Options
hot_rod
Member Posts: 25,327
under the shower floor. Add the subfloor r value and you have quite a bit of insulation to run through. better go 6" on center.
I see a product like that being used a lot around here by tile setters. But it is only 1/2" thick. Maybe yours is a sloped shower pan product?
hot rod
I see a product like that being used a lot around here by tile setters. But it is only 1/2" thick. Maybe yours is a sloped shower pan product?
hot rod
Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream
trainer for Caleffi NA
Living the hydronic dream
0
Comments
-
Anyone used...
this stuff before? It is a tile backer board that needs no vapor barrier. I am at a job w/ this being used as a shower base, it is 1.5 inches thick, and looks like styrofoam sandwiched between thin cement board. ...aka an insulator. I am doing joist trac undeneath... kpc
To Learn More About This Professional, Click Here to Visit Their Ad in "Find A Professional"0
This discussion has been closed.
Categories
- All Categories
- 87K THE MAIN WALL
- 3.2K A-C, Heat Pumps & Refrigeration
- 57 Biomass
- 425 Carbon Monoxide Awareness
- 115 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.7K Gas Heating
- 107 Geothermal
- 160 Indoor-Air Quality
- 3.6K Oil Heating
- 70 Pipe Deterioration
- 983 Plumbing
- 6.3K Radiant Heating
- 389 Solar
- 15.4K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 44 Industry Classes
- 48 Job Opportunities
- 18 Recall Announcements