I purchased a Peerless 63-03L gas steam boiler for installation this summer. Same day from Henry's Plumbing and Heating supply in Hawthorne, NJ on referral from @clammy . Same day free delivery!
I knew it would come with a CycleGuard, but why a 120v one?
Note the PressureTroll comes pre-set at 8psi cut-in
I like what @gfrbrookline is saying. You should be able to verify it by putting hands on the rads on the long main during start of cycle. I don’t think you mentioned what vents were on the short fast… (View Post)
There have been worse piping jobs on here but this one isn’t perfect. The header is nice and high but believe it or not water can carry up there and if it does that side feed out of the header isn’t … (View Post)
So with the huge EDR it would be condensing a lot of steam to water, which is having to compete with the incoming steam to get out that small supply. Is that the gist of a possible problem? (View Post)
Those photos are too close-up for me. I would need to see the whole boiler and the near piping from floor to ceiling in the pictures. I see a hot water zone coming off of it, and your radiator is not… (View Post)
If you are getting a shot of water into your radiator that is probably not the radiator or vent's fault. It is likely a bad piping situation, often at the near-boiler piping. But maybe just a slope p… (View Post)