Click here to Find a Contractor in your area.
Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.

Barbarrosa1

I have a Wirsbo/Uponor hydronic heating system installed in 1993. Total of 4 zones, 1st floor, 2 zones of pex tubing 6 thermostats 2nd 1/2 floor baseboard heat zoned with Modine heater in 2 car garage, 3 stats. 4th sone a Weil-Mclain 42 Gal. Indirect Water heater with priority. Heat source is a W-M Nat. Gas GV 4 Series 2 Boiler. Had some noise from the boiler recently & our HVAC guy found the boiler circulation pump was locked up. Having some short cycling due to the original Wirsbo/Honeywell T86H thermostats. Replacing them with Honeywell CT87K stats. Found you wire them with red (power) to R & blue (yellow) to W instead of white. This powers the 4 wire thermal actuators & closes the end switch to call for circulator & boiler to run/fire. Considering adding a Tekmar outdoor air controller. Comments?

About

Username
Barbarrosa1
Joined
Visits
4
Last Active
Roles
Member
Points
22
Badges
5
Posts
12

Activity

  • Not much happening here, yet.
Avatar

Welcome

It looks like you're new here. If you want to get involved, click one of these buttons!

Badges

First AnniversarySecond AnniversaryThird Anniversary10 CommentsFirst Comment