Bend supports for pex hr

hr · July 2002

I prefer to use regular pex for my under floor installations. It is so easy to pull thru joists and form 8" oc loops. 3/8" Wirsbo seems to be the most flexible, from my experience.
The Pex al pex products make for a nicer looking job at manifolds and near boiler piping. I bend the short pieces of PAP with an electrical condiut bender. Using these pre- bent PAP curves give me the best of both pexes.

hot rod

<A HREF="http://www.heatinghelp.com/getListed.cfm?id=144&Step=30">To Learn More About This Contractor, Click Here to Visit Their Ad in "Find A Contractor"</A>

John Felciano · July 2002

Great idea!

HR,And a nice way to use up all those scrap pieces that I hate to throw out.

To Learn More About This Contractor, Click Here to Visit Their Ad in "Find A Contractor"

Dale · July 2002

Hot Rod,Where do you connect

the regular pex with the pap? From your post picture it looks like near the manifold, I must be missing something because I thought a splice adapter of some type would be needed. Thanks

hr · July 2002

Superglue, Dale

Actually the PAP is just a sleeve to push the regular pex thru. Works like those metal bend supports you sometime see.

hot rod

To Learn More About This Contractor, Click Here to Visit Their Ad in "Find A Contractor"

Bend supports for pex hr

Comments

Categories