Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Jacobus - Maid O Mist #1

Options
rmoore007ri
rmoore007ri Member Posts: 45
in Strictly Steam
My new Jacobus - Maid O Mist #1 has what seems like an adjustment on the top. On the pic it is the knurled brass wheel that screws a cylinder into the aperture at the top. Since this vent is described as Non-Adjustable, what is this thingy for (sorry for the technical word) :-)

Comments

  • BobC
    BobC Member Posts: 5,478
    Options
    Why

    Most of their vents use this design so you can clean or change the orifice, one of the lines great strengths is you can buy the 5L radiator vents that come with 5 different screw in orifices so you can set the vent rate where you need it - that can save a lot of money when balancing a steam system.



    In the case of a main vent you want it as fast as it can be, I suspect it's built like this because they could use the same machinery on radiator and system air valves. That design should also make it easier to clean the valve if it ever becomes necessary.



    Bob
    Smith G8-3 with EZ Gas @ 90,000 BTU, Single pipe steam
    Vaporstat with a 12oz cut-out and 4oz cut-in
    3PSI gauge
  • Steamhead
    Steamhead Member Posts: 16,843
    Options
    The interchangeable orifice

    would also allow this same basic vent to be used on convectors, which require slower venting rates. 
    All Steamed Up, Inc.
    Towson, MD, USA
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Consulting
This discussion has been closed.

Categories