Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Reverse Threads on Wall mounted radiator
CB73
Posts: 6
I have a two section ornate wall mount radiator that I bought and had sandblasted. One side of the radiator has reverse threads,( by that I mean you turn left to tighten) I assume that is so that sections can be joined with one fitting. Well I cut out the lower reverse threaded plug hoping to buy a 1 1/2 reverse threaded bushing with regular threaded 1/2 for my hot water system. My local plumbing supply store did not have it and did not know where to get it. First, reverse outer and regular inner is what I am looking for correct? And seconds there a place that anyone knows of that would sell something like this, either via an online store, or by calling and having the part shipped?
0
Comments
-
Re: left hand thread bushing
I have had to have them made by machine shop. Not too painful but the most single expensive pipe fitting you will probably ever buy. Tim0 -
Re: left handed bushing
Thanks tim. I thought I might have to go that route, I just wanted an easier way out. I am in for 160 bucks for the radiator, sandblasting, fittings etc, so it WILL be put into service0 -
beautiful Conshohocken PA0
-
seen them once
around 1989 in london england on new cast iron rads. left and right close nipples
the company was in southend sorry thats all i can remember0
This discussion has been closed.
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 72 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 129 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 60 Pipe Deterioration
- 878 Plumbing
- 5.9K Radiant Heating
- 375 Solar
- 14.6K Strictly Steam
- 3.2K Thermostats and Controls
- 58 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements