Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

drop header on a steam boiler replacement

Options
Mike Miller_2
Mike Miller_2 Member Posts: 17
in Strictly Steam
Here are some pics of the boiler I just did

Comments

  • Steamhead
    Steamhead Member Posts: 16,835
    edited November 2009
    Options
    If that's your first try

    you didn't do too badly. 3-inch all the way, looks like.



    The problem is that bullheaded tee at the end of the riser. Water in the header will slam against it and get carried into the system with the steam. You want the run of that tee horizontal, the steam main coming out of the bull, then a 3" nipple and a reducing 90 to go down to your equalizer. Then the water has no place to go except down the equalizer.



    With those unions, the upgrade should be fairly painless.
    All Steamed Up, Inc.
    Towson, MD, USA
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Consulting
  • Mike Miller_2
    Mike Miller_2 Member Posts: 17
    Options
    Damn Just when I was Feeling Smug

    Thanks Steamhead, I am pretty sure Holohan's book says something about putting in tees in a bullhead placement, i.e. not to! But I guess I was too busy being clever elsewhere.
  • Gordo
    Gordo Member Posts: 857
    Options
    Don't Beat Yourself Up

    Other than that tee, a really minor thing, that's some mighty fine steam-work.



    Well done, sir.
    All Steamed Up, Inc.
    "Reducing our country's energy consumption, one system at a time"
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Baltimore, MD (USA) and consulting anywhere.
    https://heatinghelp.com/find-a-contractor/detail/all-steamed-up-inc
This discussion has been closed.

Categories