Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
AquaHeat Manifold Question
Edbrown
Member Posts: 8
We have an existing system using these manifolds and now would like to split it into 2 zones. Was hoping to add "Zone Valves" to the top of the existing valves - I have seen similiar things used, but have never installed them.
Any ideas would be great - Its in a tight location, making additional piping tough.
Thanks
Ed
Any ideas would be great - Its in a tight location, making additional piping tough.
Thanks
Ed
0
Comments
-
manifold
you can put the heat motor actuator on the manifold loops you want to control. you will have to wire the t-stats to bring on the pump / boiler / zone valves. ect.0
This discussion has been closed.
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 72 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 129 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 60 Pipe Deterioration
- 878 Plumbing
- 5.9K Radiant Heating
- 375 Solar
- 14.6K Strictly Steam
- 3.2K Thermostats and Controls
- 58 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements