Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Burnham IN11 Header Question

crash2009
crash2009 Member Posts: 1,484
I dug up these old pictures here on the wall.  As I understand it this is the header on a Burnham Independence (IN11).  According to the piping chart, in the Burnham manual, riser 1, should be 2" and drop into 3".  This 1 doesn't drop, it comes in from the side.  I was thinking that something looks screwey here but I am lost for words.

Does it make any difference if riser 1 comes in from the side of the header?  Assuming this is normal, after 1 and 2 enter the header, How far apart should they be?

Comments

This discussion has been closed.