To get email notification when someone adds to a thread you're following, click on the star in the thread's header and it will turn yellow; click again to turn it off. To edit your profile, click on the gear.
The Wall has a powerful search engine that will go all the way back to 2002. Use "quotation marks" around multiple-word searches. RIGHT-CLICK on the results and choose Open Link In New Window so you'll be able to get back to your results. Happy searching!
In fairness to all, we don't discuss pricing on the Wall. Thanks for your cooperation.

Is this good? (See pic)

JohnNYJohnNY Posts: 1,468Member ✭✭✭
Over 900 ppm CO on a ~130mbh boiler.



I'm terrified for this family and hope to be changing this boiler this week.
jpg
jpg
Image.jpg
0B
· ·

Comments

  • SteamheadSteamhead Posts: 9,109Member ✭✭✭
    edited September 2013
    Nope!

    there is probably an issue with the burner. Did you check the input rate?
    Post edited by Steamhead on
    All Steamed Up, Inc.
    "Reducing our country's energy consumption, one system at a time"
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Baltimore, MD (USA) and consulting anywhere.
    · ·
  • JohnNYJohnNY Posts: 1,468Member ✭✭✭
    Nah

    It's atmospheric. 40 years old. It's gone, baby, gone.
    · ·
  • JStarJStar Posts: 2,400Member ✭✭✭
    CO

    Is that bottom number the O2? The gas pressure is probably too high. You could lower it to a safe level temporarily.
    - Joe Starosielec
    732-494-4357
    j.star@thatcherhvac.com
    http://thatcherhvac.com
    http://facebook.com/thatcherhvac

    Guaranteed performance. Guaranteed energy savings.
    Serving all of NJ, NYC, Southern NY State, and eastern PA.
    Consultation anywhere.
    · ·
This discussion has been closed.

Welcome

It looks like you're new here. If you want to get involved, click one of these buttons!